lap joint

英 [læp dʒɔɪnt]

美 [læp dʒɔɪnt]

（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝

计算机化学

英英释义

noun

• joint made by overlapping two ends and joining them together
  Synonym:splice

双语例句

• The elasto-plastic finite element method ( FEM) was used to investigate the effect of the elastic modulus of adhesive on the stress and strain distribution in adhesively bonded aluminium single lap joint.
  利用弹塑性有限元法研究胶粘剂的弹性模量对单搭接接头应力应变分布的影响。
• When the composites are lapped in the simple way, the lap joint length has no influence on the tensile strength, but it has influence on the breaking elongation and the yield strength.
  简单搭接的拉伸强度与搭接长度无关，但对屈服强度和断裂伸长率有影响。
• This paper is to discuss the interlaminar stresses of adhesive lap joint by the energy method without considering the adhesive layer.
  本文以能量法求解无胶层厚度的搭接接头的层间应力。
• Improvement of Steel Wire Rope Core Belt Lacing Lap Joint Craftwork
  钢丝绳芯输送带接头搭接工艺的改进
• The research is carried out with the method of orthogonal test to study the effects of some main parameters such as Poisson ratio, elastic modulus and adherend of thick on the peck value of the Von Mises equivalent stress distributed in adhesively bonded aluminium single lap joint.
  运用正交试验法研究了几个主要力学和几何参数如泊松比，弹性模量和被粘物厚对单搭接接头VONMISES等效应力的影响。
• Based on the principle and process of laser transmission welding, the lap joint form was taken and the key technology and difficulty of welding were also considered.
  基于激光透射焊接的原理和过程，采取搭接接头形式进行焊接，同时焊接关键技术和难点也被考虑。
• Test shows that this way can exhibit good result to butt joint and lap joint of TIG welding and accurately abstract welding seam out, to the welding seam of large magnitude dogleg angle shows good tracking effect ( dogleg angle< 68 °) and procession speed< 100 ms.
  实验表明，系统对TIG焊的对接和搭接焊缝有很好地处理效果，对大幅度折线焊缝也能很好的跟踪（折线角>68°），处理速度>100ms。
• By comparing the results of buckling analysis, the effects of material nonlinearity, geometric imperfection and lap joint on stability were studied.
  分析了材料非线性、几何缺陷和筒壁搭接对稳定性能的影响。
• The lap joint produces bending effect under the action of tensile load and the bending degree decreases with the increase of yield limit of base material.
  搭接接头在拉伸载荷作用下会产生折弯效应，折弯程度随被钎焊母材屈服极限的增加而减小。
• Effect of Environmental Temperature on Strain in Adhesive Layer of Single Lap Joint
  单搭接接头胶层中的温度应变研究